I noticed that the probe attached perfectly but no connection! We can call it unit testing as done in software development. The klicky-NG.ĭuring installation I always do testing. Belt where tensionen and over to the klicky. ![]() ![]() On Saturday the rest of the parts where installed. In the middle of work the manager showed up and inspected the work. So, the work with cleaning and greasing the rails as well as finalizing the assembly of the frame and gantry began. ![]() I bought the IPA from a Paint Shop down south of in Sweden for a really good bargain. Over and above the Isopropanol that I waited for, it had a Happy Eastern card and some candy! If anyone has an idea on how to correct that, I appreciate every hint or suggestion.įinally in the afternoon, the phone beeped and Yeay! We got a delivery! The model had 3 mm but my prints came out with a height of 3.3 mm but if I slice and use CURA it is more or less correct. The only thing that wasn't really good was the Z height of my test print. It was really a step up, after tweaking the X-Y settings, I got really nice prints with an error of 0.02-0.04 mm on all edges as well as holes. I installed and configured Superslicer, and created an almost exact copy of my Cura profile for the PETG I have and tried it out. But now I felt that it was time to upgrade. Until now, I have used Cura with my Ender 3 Max and it has worked ok. So today I re-flashed the motherboard with CanBoot and a new Klipper image as well as created a stub for a shell script to flash the motherboard and toolhead (as I will forget all the commands and most probably where I found them ). They have already passed customs, so if we are lucky it could arrive before the weekend. Now it has the required contact so when doing the conductivity test on the magnets it is 100%.Īt first I thought I would start by installing the wire-harness and PCB that came with the kit, even though I already decided I will use CAN with this printer.īut as I hate to redo work, I changed my mind and decided to install CAN from start.Īs I will use the Linux-box with three different printers, I don't want to have 5-6 USB cables attached to it, so as the Fysetc Spider has a CAN interface I ordered the required CANBUS expander module and a SB CAN Toolhead board from Fysetc. Sunny day with a lot of snow made this course quite hard as the orange clay was hard to see from above.ĮDIT: Forgot to tell, the wires for the Klicky-probe that Fysetc provided are a little bit too thin as the magnets didn't had 100% contact, so I had to strip the wires to double length, fold in half and twist it so I got at least double area. Managed to get one at least when the round was almost over. ![]() I always forget to take pictures when shooting. Printing ABS on the E3Max is not providing any good prints and as I got the aluminium part kit I decided to just print the bare minimum parts in PETG and treat them as "wasteable".Īs soon as I have Goldie up and running I will print the parts in ABS. I haven't thought of extra mods like brushes or purge buckets, so this will be ok for a starter. I decided to go with the Klicky-NG but the Fysetc included kit was for the original mounts so a lot of the provided hardware is not needed however you need some extra M2 selftapping screws.Īs gantry-mount I started with the fixed mount. After the main activity yesterday, all work that was done was the assembly the klicky-probe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |